Smart-Vac

Model shown is 858-1200-805 with inlet and outlet filters for removing 99.5% of all particulates as small as 3 microns. The vacuum distillation process is capable of removing water at over 15 gallons per hour. Oil can be dried to less than 70ppm in 7-10 passes.

The 858-1200-805 Smart-Vac removes water & solid contaminate from large oil reservoirs. It can be used on hydraulic, lubricating & silicone oils.

The Smart-Vac is an electronic control feature which adjusts the flow rate for optimum water removal rate. The Smart-Vac monitors oil temperature, suction conditions and flow through the vacuum process chamber. It then determines the optimum flow and adjusts the flow rate from 300 gph to a maximum of 1200 gph.

• Removes Solids
  Dyna-Glass II Filter Elements to 3 micron Beta200
• Removes Water
  All water... Free, Emulsified and Dissolved to less than 70ppm
• Removes Gases

Smart-Vac's safely to remove water, gases and particulate matter from:

• Lubricating Oils
• Hydraulic Oils
• Mineral or Synthetic Oils
  

Highest water removal rate available
The 858-1200 Smart-Vac is an oil purification system used to remove water and solid contamination from large oil reservoirs. It can be used on hydraulic, lubricating, and silicone dielectric oils. The Smart-Vac uses the best technologies available from FilterDyne. The Smart-Vac automatically adjusts the process flow rate from 300 to 1200 gph depending upon oil viscosity, temperature, and vacuum. The Smart-Vac uses a PLC controller to adjust itself for the optimum water removal efficiency without operator involvement.

Durability
FilterDyne uses liquid ring pumps to create the vacuum condition for distilling the water. These type pumps are designed to pump vapors and liquids without damage.

FilterDyne's 858-1200-805 Smart-Vac removes water from oil by vacuum distillation. Water is separated from oil at rates up to 15 gallons/hour. Oil properties are not altered in this process.